You are here: Troubleshooting > Error Codes > Errors 60-69 > Error 64
Error 64: Following Error Y‑axis
The Y‑axis servo motor was not able to move freely to the required position.
What to do now
Rehome the saw.
What to do next
- Press the E‑stop button and look for any obvious reason why the motor would not be able to move freely. A common cause is a build-up of saw dust in the Y‑axis assembly or small pieces of wood getting stuck somewhere. With the control off, try to manually move the Y‑axis by hand in both directions - remove the rectangular aluminium rear end cover of the Y‑axis assembly to gain access to the timing belt.
- Ensure that the Y‑axis ball screw nut and linear bearings have been getting greased appropriately as per the routine maintenance requirements.
- Ensure the correct lithium-based grease is being used when greasing the Y‑axis (Castrol Spheerol EPL 2 recommended).
- Check the condition of the ball screw, ball screw nut, and linear bearings by moving the unit manually and in Manual Mode. Visually inspect these components.