Check the print head alignment

WHAT YOU NEED 

Standard Personal Protective Equipment

CAUTIONWhen using the manual mode, make sure that everything and everyone is clear of moving parts to prevent damage or injuries.

1. Make sure the saw is homed.
2. Open the PEWIN32PRO program.
3. In the terminal window, type "Q295=70" (if using 35‑mm-thick boards) or "Q295=90" (if using 45‑mm-thick boards) then press the Enter key.
4. Using the Manual Mode window, feed two 90‑mm-wide boards stacked one on top of the other into the saw and move them towards the outfeed until they are positioned under the print heads.
5. Open the plate marking control panel and click  at the top left of the panel (for print module 1 only).
6. Move the boards further to the outfeed so that you can see the printing.

7. Inspect the printing for any misalignment of the print heads.

   Note: if the print heads are significantly misaligned from one to the next (i.e. more than about 0.5 mm), contact Vekta Automation for help in realigning.

8. Hold down the red STOP button on the operator console for 3 seconds and remove the timbers from the saw.
9. In the terminal window, type "Q295=35" or "Q295=45" (depending on the thickness of the boards used) then press the Enter key.
10. Using the Manual Mode window, feed two 90‑mm-wide boards stacked side by side into the saw and move them towards the outfeed until they are positioned under the print heads.
11. Click  at the bottom right of the plate marking control panel (for both print modules).
12. Move the boards further to the outfeed so that you can see the printing.

13. Inspect the printing for any misalignment of the print heads.

    Note: if the print heads are significantly misaligned from one to the next (i.e. more than about 0.5 mm), contact Vekta Automation for help in realigning.

14. Hold down the red STOP button on the operator console for 3 seconds and remove the timbers from the saw.
15. Close the plate marking control panel.
16. Close the PEWIN32PRO program.